I took me a couple of years but eventually found the time to build the BOM and a simple documentation guide for the DHT LT supply PCB. I’ve been using this PCB for a long time on most of my DHT preamps and in my current 300B SE Amplifier.
It’s a 16 x 8 cm board which can be stacked for a stereo DHT stage. Enough flexible is provided for all sort of filtering combinations (either choke to cap input supplies).
Some may say is a killer, but I add a common-mode choke to suppress HF noise from mains. I design my supplies with a no-compromise thinking and best possible components (e.g. including split-bobbin main transformers), chokes and capacitors to deliver the lowest noise possible to the filament supply.
This board doesn’t replace the filament regulator (e.g. Rod Coleman regulator), it’s just the raw supply circuit needed before them.
I will sell the remainder of my stock of these lovely ENIG finished PCBs. You can order them here.
