Category: 300B Amp

Flexible HT supply

The return of the Jedi

Time has come when breadboarding and HT is not longer an option. With a baby around, I was forced to remove most of the valve equipment. However, the return of the Jedi is closer than you expect. With very little time, albeit at continuous pace when I get a free 30min here or there every weekend, I keep very focused on my objective. The 814 SE monster amp is close to retirement (probably before Christmas) and although I have a fantastic LME amp already working, I need to get the valves back on the scene providing I can prove I’ve complied with “heath and safety” – as my wife well put it.

Well, I had a nice attempt of a wooden frame made out of pine wood. Yes, I’m really bad at woodworking but I’m getting better. The top plates are 4mm thick. I have added a nice set of 2 100mA meters at the front of the frame. A 300VA custom-wounded multi-tap HT transformer from JMS which gives me full flexibility from 100 to 500V in 25V steps. The supply is choke input (LL1638) and filtered with a set of nice 50uF oil caps and 20H chokes. Damper valves used with some nice SiC to form a hybrid rectifier.

Top plates are protected with paper before drilling!

This looks to be quite neat in my view!

The idea is to use this supply for my new 4P1L PSE, 300B and DHT Schade experiments with 6P21S/47 and 1624 valves. A lot planned and so little time for this unfortunately.

Cheers, Ale

 

 

 

 

Popping the Shunt Voltage Regulator’s clogs

Not a surprise

What I suspected it was going to happen, it did in the end. Although a bit premature and in a bad time. I’m expecting today a friend to come around for a listening session and having no amp wasn’t an option.

To cut a long story short, the Salas SSHV2 shunt regulator has been playing silly buggers for a long time. Since I upgraded the output transformers and readjusted the bias, it looks like I was operating it at the verge of its abilities. The CCS was running at 80-90mA and somehow the stability of the shunt regulator was compromised. Initially was a periodic lost of regulation during warm up, this created an annoying “pop” now and then,  later I decided to replace it with a new SSHV2 and blew a pair of DN2540 after the regulator failed to set the output voltage randomly. It worked fine on the test bench, however there is something on my system which is disturbing / interfering with the regulator or the regulator isn’t stable enough at the hot operating conditions I was submitting it to.  I have nothing against the SSHV2, in fact, I use it extensively in my preamps. However, I think I’ve found the limit at which it can safely operate. The additional drawback of the SSHV2 is its temperature stability. It’s not great as it drifts when temperature rises.

So the regulator went busted on Thursday evening and I was running out of time. Only Friday was available to fix the amp. Luckily, I was on holidays this week and had the time to fix this, but unfortunately this diverted my energies and time from the 300B amp 🙁 Continue reading “Popping the Shunt Voltage Regulator’s clogs”

300B Amp: the journey starts here

I can’t get away from my big HT power supplies. This time the HT +400V for the 300B amp is here. Lots of Lundahl iron and a lovely hybrid bridge made of mercury rectifiers and damper valves. Yes, I’m in love with the blueish colour of the 816s. Despite they are mercury rectifiers, I know.

I promised the wife I’d get a smaller amp, that was my excuse for the 300B reference system. Still this is not going to be small, however, it will be compared to the 814 SE Amp!