Tag: 45

Driving the 45 DHT in A2

20130126-092606.jpg

Having had a great exchange of comments with “45” in a previous post, I thought it was easier to post this after doing some simulations with the 45 DHT in A2 operation.

I’m a great fan of the 45 valve. I think is probably the best sounding DHT out there. I listened to 300B, 2A3 and even 4P1L as an output valve, but nothing compares to me to the warm sound of this valve.

Later specifications of the 45 show that you can push it to 10W of anode dissipation. I’m currently using it at Ia=34mA, Vak=300V with an 2.5KΩ OT. You could get 2W out, but at the moment I’m squeezing 1.5W at maximum drive. There is a way of getting more out of the valve which is obviously by driving it in A2 (i.e. positive grid current). My current project (4-65A SE in class A2) uses a gyrator-loaded driver and stacked supplies which work brilliantly in A2. The driver provides sufficient grid current at low impedance even when the input impedance of the output valve drastically changes when grid current kicks in closer to 0V.

I have a pair of LL1623/60mA which I’m planning to use in the future to try 4P1L PSE or 6C4C output stages. This OT can be configured for 5.6KΩ, 3KΩ and 1.6KΩ anode loads.

Here is a first simulation of the 45 operating in class A2. The bias point was changed now down to 210V/47mA as the OT is configured for 3KΩ load:

45 loadline in A2 version 2The anode AC power is then:

P{}_{a}=\frac{1}{2}\cdot i{}_{ap}^2\cdot Z{}_{a}

So roughly for Iap=46.5mA and Za=3KΩ, then Pa=3.2W. This is about 32% efficiency. More than double of the current juice I’m getting out of this valve, but at the expense of pushing the grid to +32V and anode peak current of 93-94mA. Grid current should be around 3-5mA from what the AB2 data looks like.

Question is here, is it worth trying this? Complexity of the amp is on the stacked power supplies. The driver will need to swing easily 120Vpp, so a well designed 4P1L in filament bias can do this with minimum distortion.

Thoughts?

 

 

45 SE Amplifier upgrade

Replacing driver for 7193 valve

Well, after nearly 12 months of playing relentlessly my 45 SE amplifier, had an unexpected failure in the power supply (passive regulator) which forced me to do maintenance to the amplifier. It was a great opportunity to remove the 6J5 driver and do a quick swap for the greatly respected 7193 (i.e. military version of the 2c22)

45SE Amplifier upgraded with the 7193 drivers

Bias point remains unchanged: 7mA and 260V for maximum swing and minimum distortion. Need to look at my notes, but I remember that I was something around 0.30% at 100Vpp driving the 45 (which is not an easy load for anyone).  Driver configuration was not changed, so had the 7193 now loaded with same DN2540 single transistor gyrator and mu-follower output for lower impedance. The valve was biased at about 8V with an LED array.

7193 in action

As a test, played the fantastic Symphony No. 3 from Henryk Gorecki….