I’ve been posting not very frequently lately. This is mainly due to lack of time and the level of business travel which reduced to nearly none the time available for DIY audio.
Nevertheless, the scarce time always pays off. It’s incredible how selective I have to be in order to prioritise which project I should work on. The list is long though.
Last time I did a quick exercise on the Ba DHT based on the curves I traced and the LTSpice simulation. Well, you always need to build and test in order to check against simulations. The result is, that you may need to adjust and learn from your practical experiences.
The Ba (like the Aa) are tricky to use. They pick up any electrostatic induced noise. You don’t need even to place your hand close, the mains noise is induced already in its plate. This force you to shield these valves if you want to use them. Am afraid, that is what it is. My friend Rob (DHTRob) warned me, thank you.
The circuit I posted here, had to be readjusted. Distortion was way too high. The operating point wasn’t good enough. You’d normally get inclined to run the valve as hot as you can, but I was wrong here with this one.