Long time ago I breadboarded the 1624 valve and liked the sound. The 807 is famous and I never ended up with a permanent system with this valve. Yet, I like it. And if you have them at hand, use them. Even for guitar amps are amazing.
Tag: Schade
Pentode driver with feedback (Part I)
It was about time to get my hands on this driver experiment. I’ve been trying to find the time for a while and could only make it due to the obliged COVID-19 isolation upon return from holidays.
The idea is simple. I wanted to use a pentode driver to swing large volts (e.g. 200Vpp) whilst retaining the triode-like characteristic from harmonic perspective and low distortion. A nice challenge and fun to work on.
Have to say that the parallel/parallel feedback (also referred to as “Schade feedback” by some in audio) when applied locally in the output stage, does sound very nice and is a very nice way of implementing high-gm pentodes used for vertical service in TV. They can produce very low distortion and sound amazing when implemented correctly. I’m not covering this now, as it has been dwelled on for some time by many good people out there.
The circuit topology is as follows:
47 Push-Pull with local feedback
This design is inspired on the great work from Gary Pimm. The 47 is a sterling directly heated pentode and worth using it. I have several on my stash, including some good globe versions.
“Schade” SE Amp Example
Introduction
On my last post I covered how the gyrator PCB can be used in a pentode driver. The pentode driver is the best candidate in a “plate to plate” / shunt feedback or “Schade” feedback amplifier which is the name typically used in the DIYAudio world. The triode doesn’t work well here as you need high gain and low distortion with a load which can get quite low (due to the feedback effect of the feedback resistor). I’m not going to cover the subject as it has been covered (and discussed) extensively before by many people, so I suggest you do a bit of research yourself if you are interested in the subject and want to learn more.
A Study example
Flexible HT supply
The return of the Jedi
Time has come when breadboarding and HT is not longer an option. With a baby around, I was forced to remove most of the valve equipment. However, the return of the Jedi is closer than you expect. With very little time, albeit at continuous pace when I get a free 30min here or there every weekend, I keep very focused on my objective. The 814 SE monster amp is close to retirement (probably before Christmas) and although I have a fantastic LME amp already working, I need to get the valves back on the scene providing I can prove I’ve complied with “heath and safety” – as my wife well put it.
Well, I had a nice attempt of a wooden frame made out of pine wood. Yes, I’m really bad at woodworking but I’m getting better. The top plates are 4mm thick. I have added a nice set of 2 100mA meters at the front of the frame. A 300VA custom-wounded multi-tap HT transformer from JMS which gives me full flexibility from 100 to 500V in 25V steps. The supply is choke input (LL1638) and filtered with a set of nice 50uF oil caps and 20H chokes. Damper valves used with some nice SiC to form a hybrid rectifier.
Top plates are protected with paper before drilling!
This looks to be quite neat in my view!
The idea is to use this supply for my new 4P1L PSE, 300B and DHT Schade experiments with 6P21S/47 and 1624 valves. A lot planned and so little time for this unfortunately.
Cheers, Ale