All about electronic valves and hi-fi
It’s been a while since I experimented with preamps again. I settled as a permanent setup with my 01a/ER801a which I love. However, I wanted to continue with my experiments so I built a new Mule, let’s call it “Mule 2” for now. It’s based out of multiple PCBs which simplifies the construction process and reduces build time:
Obviously it was time to test the little brother of the “Ba” DHT. In particular, as I have such a low DAC in place now, I need the gain. With nearly a gain of 30, it’s an attractive fellow to work with.
First good sign is that it doesn’t pick up as much hum as the Ba. That’s good, nevertheless I placed a back copper plate which acts as enough earth shielding to keep the Ba quiet.
I worked with my breadboard to find a good “sweetspot”( at least electrically) for this valve. Given the low signal source level, I aimed for a low bias. I played with my fixed bias setup before replacing it with the SiC bias board. I found that 2V/160V was very good in terms of keeping the distortion profile to minimum. Here is what I ended up with:
Only 2 SiC diodes are enough. The source follower PCB is mandatory given the low anode current. I run it at 20mA (hot) to get best results of the stage. Rest of the circuit is very simple, achieving a gain of about 30. Here is the distortion profile:
There is no shielding and you can see some minor IM distortion with mains hum. Harmonic decay is nice with H2 being strongest. THD is very low at 4Vrms which is good sign. Let’s see the frequency response now:
Nearly 140kHz of bandwidth which is plenty for the stage. Great response. I just need to plug this one in and listen to this promising German DHT.